Drimit Link Open Standard

1 Pogo Connector Mechanical System

1 Connector Specifications (P75-E2, 1.27mm pitch)

  - Connector Part Number and Manufacturer Requirements
  - Dimensional Tolerances and Alignment Specifications
  - Spring Force Characteristics and Travel Distance
  - Electrical Contact Specifications and Resistance

Technical Drawing Required: Pogo connector detailed mechanical drawings

Specification Sheet Required: Connector electrical and mechanical parameters

2 Material Requirements (Gold-plated contacts)

  - Base Material Specifications (Copper alloy, spring steel)
  - Gold Plating Thickness and Quality Requirements (0.5-2.5μm)
  - Corrosion Resistance and Environmental Testing
  - RoHS Compliance and Material Safety Documentation

Material Specification Required: Material composition and testing standards

3 Mating Force and Retention (2-8N insertion, >5N retention)

  - Force Measurement Test Procedures and Equipment
  - Force Tolerance Specifications and Acceptance Criteria
  - Retention Force Degradation Over Time Analysis
  - Force Variation Across Temperature Range

Test Procedure Required: Force measurement methodology and equipment setup

4 Durability Requirements (>10,000 cycles)

  - Cycle Testing Procedures and Pass/Fail Criteria
  - Wear Pattern Analysis and Failure Mode Assessment
  - Accelerated Life Testing Protocols
  - Maintenance and Replacement Recommendations

Test Protocol Required: Durability testing procedures and lifecycle analysis

This site is open source. Improve this page.